PRODUCT
Stainless Steel Powder Coating Line
A powder coating line built with SS304 booth panels and stainless oven liners, for appliance, medical and food-equipment production where washdown and hygiene matter.
Mild-steel booth panels are a false economy where the booth interior has to be washed between colour changes or shifts. In this line the booth body, ducting and recovery unit are fabricated in SS304 with welded seams and no exposed fixings.
Stainless oven liners also prevent rust staining on parts and extend panel life in humid or coastal climates – a real issue for plants in tropical and coastal regions. The pretreatment, conveyor, guns and controls are the same as our standard powder line.
- SS304 booth body, ducting and recovery unit
- Washdown interior for hygiene-critical production
- Stainless oven liner against rust staining
- Suitable for humid and coastal climates
- Standard pretreatment, conveyor and gun packages

| Item | Typical specification |
|---|---|
| Booth material | SS304 |
| Oven liner | stainless steel |
| Application | appliance, medical, food equipment |
| Recovery | cyclone or cartridge |
Not sure which configuration fits your parts?
Send us your workpiece size, coating type and required output per shift. We reply with a line proposal and a budget range within one working day.
Why stainless parts need a different line
Stainless steel and galvanised parts react badly to standard iron phosphating: the coating can flake at bends and rust appears at weld seams. This line uses a stainless-appropriate pretreatment sequence and a booth and oven sized for thinner films, so the finish stays even on brushed and mirror surfaces.
- Kitchen equipment and commercial refrigeration panels
- Stainless housings for medical and food machinery
- Appliance fronts and elevator panels
- Stainless furniture and handrails
Configuration notes
Degreasing is followed by a rinse and a suitable conversion or passivation stage, with DI-water rinse where water hardness is high. Because stainless parts are often large and flat, booth width and oven opening are calculated from the panel size, and the conveyor uses a low-vibration chain to avoid marking the surface.
Film thickness is usually kept at 60–80 µm for a smooth appearance; powder selection (polyester or polyester-urethane) is matched to the indoor or outdoor use of the part.
Questions buyers ask
Do we need a full 5-stage pretreatment?
Not always. For indoor panels a 3-stage sequence is often enough. For outdoor or food-contact equipment we recommend 4–5 stages with a passivation rinse, and we will state which stages are required in the proposal.
Can the same line also coat carbon steel parts?
Yes, but the pretreatment chemistry has to suit both. We will specify a sequence that works for the mix of materials you actually run, rather than assuming a single substrate.