PRODUCT
High Quality Standard Conveyor
A continuous overhead chain conveyor for coating lines, with fixed-pitch hangers and VFD speed control.
The chain runs on an I-beam track with hangers at fixed pitch; pitch and speed together set output per hour, both calculated from your parts-per-shift target and oven dwell time.
Components inside wet and hot zones are stainless or plated so they survive pretreatment chemicals and oven temperature. A geared motor with variable frequency drive gives 0.5-6 m/min adjustment for product changes.
- I-beam track with fixed-pitch hangers
- VFD speed control 0.5 – 6 m/min
- Stainless or plated parts for wet and hot zones
- Automatic lubrication and chain take-up
- Hanger load 50 – 500 kg



| Item | Typical specification |
|---|---|
| Speed | 0.5 – 6 m/min |
| Hanger load | 50 – 500 kg |
| Chain | galvanised or stainless |
| Drive | geared motor + VFD |
Not sure which configuration fits your parts?
Send us your workpiece size, coating type and required output per shift. We reply with a line proposal and a budget range within one working day.
Standard overhead conveyor for coating lines
This is the continuous chain that carries hangers through pretreatment, booth, oven and cooling at a steady speed. It is the lowest-cost way to move parts through a line when every station can run at the same takt time.
- Variable speed 0.5–6 m/min by VFD
- Hanger pitch set from part length plus clearance
- Drive units sized for the heaviest hanger load
- Turns, inclines and spare track for later extension
Chain and track are galvanised or painted, with drip trays over the booth and oven areas. The drive is interlocked with the line so that a stop also stops the guns and holds the oven temperature.