PRODUCT
Spraying Type Pretreatment Line
A spray tunnel with arches at each stage, for flat and simple parts at high line speed with lower chemical consumption per part.
Parts pass on the conveyor through spray arches at each stage: degreasing, rinse, conversion coating, rinse, passivation. Nozzle layout and pump pressure are set so every surface is covered, including the underside.
Because parts are not immersed, tanks are smaller and chemical consumption per square metre is lower. The limitation is geometry: deep recesses will not be fully coated, which is why immersion remains the choice for complex parts.
- Spray arches with matched nozzle layout
- 3 – 5 stages, tunnel type
- Blow-off and drying zone at exit
- Lower chemical consumption per part
- High throughput for flat parts






| Item | Typical specification |
|---|---|
| Type | tunnel with spray arches |
| Stages | 3 – 5 |
| Coverage | flat and simple geometry |
| Drying | blow-off + hot air |
Not sure which configuration fits your parts?
Send us your workpiece size, coating type and required output per shift. We reply with a line proposal and a budget range within one working day.
Dipping pretreatment — full coverage for complex parts
When parts have closed sections, hollow tubes, welded frames or stacked small components, spraying cannot reach every surface. Dipping immerses the whole part, so every internal surface is wetted and converted, and the coating adheres where it is hardest to reach.
- Tanks sized from the largest part and its basket or hanger
- Overhead hoist or conveyor dipping with controlled dwell time
- Heating, filtration, skimming and agitation per stage
- Tank lining and material selected for the chemicals used
The trade-off is chemical drag-out and larger tank volume. We size the tanks and rinses so that drag-out is controlled, and we can add a drain board or air-blow stage between tanks to reduce loss.