PRODUCT
Workpiece Detecting System
Photoelectric part detection that fires each gun only when a workpiece is in front of it, cutting powder waste and booth cleaning.
Guns spraying empty conveyor gaps waste powder and coat the booth walls, which then has to be cleaned. Sensors at booth entry and exit detect part presence, and the controller delays gun-on and gun-off by the conveyor travel time so the spray lands exactly on the part.
The result is typically 10-25 % less powder consumption and far less cleaning, with no change in film thickness. It also stops powder building up on empty hangers, where it later flakes off onto good parts.
- Photoelectric entry and exit sensors
- Gun on/off delay matched to conveyor speed
- Per-gun switching
- Typically 10-25 % less powder used
- Can be retrofitted to existing lines

| Item | Typical specification |
|---|---|
| Sensors | photoelectric, entry and exit |
| Function | per-gun switching with travel delay |
Not sure which configuration fits your parts?
Send us your workpiece size, coating type and required output per shift. We reply with a line proposal and a budget range within one working day.
Workpiece detecting system — coat only where there is a part
Guns that keep spraying into an empty hanger waste powder and coat the booth. A workpiece detector uses sensors at the booth entry to switch guns on when a part arrives and off when the gap comes, so consumption drops and the booth stays cleaner.
- Photo-electric or laser sensors at booth entry
- Gun zones switched independently along the booth
- Works with manual and automatic guns
- Simple integration with the line PLC
Savings are largest on lines with wide gaps between hangers, or with parts that occupy only part of the booth height. We size the number of zones from the booth layout and the part pattern you run.