PRODUCT
Powder Coating Gun
Electrostatic powder gun with separately adjustable kV and current, manual or automatic, GEMA-compatible or matched to the control unit you already own.
Voltage and current are the two settings that decide how a powder behaves on a part: high kV for wrap-around on complex shapes, lower kV to avoid faraday-cage problems in recesses and to control film build on edges.
Guns are supplied GEMA-compatible or specified to your existing control unit, so you can add guns to a line without replacing the whole electrical system. Flat, round and extension nozzles cover most geometries.
- Adjustable kV and current
- Manual or reciprocator-mounted versions
- GEMA-compatible or per customer requirement
- Flat, round and extension nozzles
- Powder output 50 – 500 g/min



| Item | Typical specification |
|---|---|
| Voltage | 0 – 100 kV |
| Current | 0 – 100 uA |
| Powder output | 50 – 500 g/min |
| Type | manual or automatic |
Not sure which configuration fits your parts?
Send us your workpiece size, coating type and required output per shift. We reply with a line proposal and a budget range within one working day.
Powder coating gun: what the spec sheet should tell you
The gun sets how much powder reaches the part and how much is wasted. Two numbers matter most: the charging efficiency at the part surface, and the consistency of the powder feed from the hopper.
- Manual or automatic (reciprocator-mounted) versions
- KV and µA adjustable per gun, with presets per recipe
- Venturi or dense-phase feed, matched to your powder type
- Spare parts available for the life of the line
We supply GEMA-compatible guns or any brand the customer specifies, and quote the full set of wear parts — nozzles, electrodes, venturi tubes, powder hoses — with the initial order so that production is not interrupted waiting for a single part.